The handle of the cranked handles with retractable handle GN 471. 3 is locked in a tapered bore in the operating position. For tilting, the handle must first be pulled out of...show more
The design of the cranked handles GN 670.2 matches the product family Ergostyle®. Attaching the cranked handle on a shaft using a transverse pin or a set screw is made easier...show more
The hub bores d1 H7 are not provided for in the official standard sheet.
Cranked Handles, Aluminum
Tri-ball handles GN 10 allow fine adjustment. An alternative in modern design are cranked handles GN 510 and control handles GN 112.1.
Stainless steel cranked handles GN 269 have been designed to comply with stringent hygiene requirements. The cylindrical handles are made of thermoset material which in general...show more
Control handles GN 112.1 allow fine adjustment. They are connected to a shaft by means of a cross pin. To simplify the installation there is a centred drilling on both sides.
Indexing cranked handles GN 558 are for positioning mechanisms. Other standard machine elements for positioning of spindles: - Indexing Mechanisms GN 200 - Indexing Levers GN...show more
Cranked handles GN 510 allow fine adjustment. These cranked handles are fitted to shaft with a cross pin. To simplify the installation there is a centred drilling on both sides.
Cranked handles GN 570.2 are connected to a shaft by means of a cross pin. Owing to the small, non-protruding steel bushing, these cranked handles are lower priced than GN 570.
The protruding steel bushing of cranked handles GN 570 ensures an accurate bore and square to bore face. It can be retained with a pin or a retaining screw. The link between the...show more
The design of the cranked handles GN 670 matches the product family Ergostyle®. The protruding steel bushing ensures an accurate bore and square to bore face. It can be retained...show more
The handle of the cranked handles with retractable handle GN 472.3 is locked in a tapered bore in the operating position. For tilting, the handle must first be pulled out of the...show more
The handle of the cranked handles with retractable handle GN 472.5 is locked in a tapered bore in the operating position. For tilting, the handle must first be pulled out of the...show more
Cranked handles GN 570.3 are connected to a shaft by means of a cross pin and are used for applications where the handpiece has to stay occasionally in its retracted position....show more
The protruding steel bushing of cranked handles GN 570.1 ensures an accurate bore and square to bore face. It can be retained with a pin or a retaining screw. The link between...show more
Cranked Handles, Zinc Die Casting
